Pemanfaatan Panel Surya Fotovoltaik untuk Energi Berkelanjutan di Daerah Terpencil

Dewi Puspita Sari; Wadirin Wadirin; Edi Setiyo; Dendy Adanta; Marwani Marwani; Anthony Costa

doi:10.36706/jrm.v25i1.1405

Authors

Dewi Puspita Sari Program Studi Pendidikan Teknik Mesin, Universitas Sriwijaya, Sumatera Selatan, Indonesia
Wadirin Wadirin Program Studi Pendidikan Teknik Mesin, Universitas Sriwijaya
Edi Setiyo Program Studi Pendidikan Teknik Mesin, Universitas Sriwijaya
Dendy Adanta Jurusan Teknik Mesin, Fakultas Teknik, Universitas Sriwijaya
Marwani Marwani Jurusan Teknik Mesin, Fakultas Teknik, Universitas Sriwijaya
Anthony Costa Jurusan Teknik Sipil, Fakultas Teknik, Universitas Sriwijaya

DOI:

https://doi.org/10.36706/jrm.v25i1.1405

Keywords:

Solar panel, energy efficiency, photovoltaic, renewable energy

Abstract

This study explores the utilization of photovoltaic solar panels as a source of electrical energy to meet the needs in hard-to-reach areas. Using experimental methods, data were collected during observations from September 13 to September 18, 2024, encompassing measurements of voltage, current, and solar radiation intensity. The results indicate that the highest panel efficiency reached 25.12%, while the lowest was 19.25%, significantly influenced by sunlight intensity and panel temperature. Additionally, the highest convective heat transfer coefficient was recorded for Panel 1 at 96.64 W/m²K, showing a direct relationship with thermal conditions. This research emphasizes the importance of system design and the management of environmental factors to enhance panel efficiency. These findings open opportunities for the development of cooling technologies and more efficient energy conversion in the future.

Downloads

Download data is not yet available.

References

KESDM, “Rencana Umum Energi Nasional,” Jakarta, 2017.

F. Rajaee, M. A. V. Rad, A. Kasaeian, O. Mahian, and W. M. Yan, “Experimental analysis of a photovoltaic/thermoelectric generator using cobalt oxide nanofluid and phase change material heat sink,” Energy Convers. Manag., vol. 212, 2020, doi: 10.1016/j.enconman.2020.112780.

H. Satria, S. Syafii, R. Salam, M. Mungkin, and W. Yandi, “Design visual studio based GUI applications on - grid connected rooftop photovoltaic measurement,” TELKOMNIKA Telecommun. Comput. Electron. Control, vol. 20, no. 4, pp. 914–921, 2022, doi: 10.12928/TELKOMNIKA.v20i4.23302.

S. Hidayat, “Pengisi Baterai Portable dengan Menggunakan Sel Surya,” J. Energi dan Kelistrikan , vol. 7, no. 2, pp. 137–143, 2015.

M. B. Hayat, D. Ali, K. C. Monyake, L. Alagha, and N. Ahmed, “Solar energy—A look into power generation, challenges, and a solar-powered future,” Int. J. Energy Res., vol. 43, no. 3, pp. 1049–1067, 2019, doi: 10.1002/er.4252.

S. Zhang and Y. He, “Analysis on the development and policy of solar PV power in China,” Renew. Sustain. Energy Rev., vol. 21, pp. 393–401, 2013.

A. K. Katiyar and C. K. Pandey, “A review of solar radiation models—Part I,” J. Renew. Energy, vol. 2013, 2013.

W. F. Octavian, R. Hidayat, and L. Nurpulaela, “Perancangan Umbrella Energy Sebagai Charger Handphone Pada Cafe,” J. Energi Dan Manufaktur, vol. 13, no. 2, p. 82, 2020, doi: 10.24843/jem.2020.v13.i02.p07.

R. Senthil, G. Vijayan, G. Phadtare, and B. Gupta, “Performance enhancements of solar dryers using integrated thermal energy storage: a review,” Recent Adv. Mech. Eng., pp. 355–362, 2021.